mcarterbrown.com

mcarterbrown.com (http://www.mcarterbrown.com/forums/)
-   Ask The Experts (http://www.mcarterbrown.com/forums/ask-experts/)
-   -   Marq Noid Question (http://www.mcarterbrown.com/forums/ask-experts/226288-marq-noid-question.html)

grimcpt 02-14-2013 12:03 PM

Marq Noid Question
 
What kind of molex connector does it use, where can i get one and how hard is it to get it crimped? Basically i pick up a marq and the only thing wrong is the guy pulled off the connector. If I can fix it for under 30$ it would be 100% worth it. I am also marginally competent when it comes to working with electronics and wiring.

TechPB-Mike 02-14-2013 12:08 PM

the crimpers that you'll need, are going to cost quite a bit of money. Last I check they were about $30

What you can do, is try some pre-built molex leads, and solder your wires into those leads.

Also, see if you can send it into Bob Long to be repaired, they have the tools and everything to put a new connector on that solenoid. It'll be ALOT cheaper and much less hassle than trying to fix it yourself

grimcpt 02-14-2013 12:15 PM

Thanks Mike, I did not think of the soldering option, good idea. I don't mind buying the crimpers, i'm sure they would be a good investment. Thanks again for the input!


All times are GMT -4. The time now is 07:24 AM.

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO
© MCB Network LLC