Delta 68 pistol leak
I think the round metal piece that houses the pierce pin and o-ring where the CO2 goes into has a tool mark that causes it to leak. Anyone know where to get parts for this? I am guessing I need the valve face itself.
Believe it or not, RAP4 has the parts, same as a T68 pistol.
I just bought a 4x rebuild kit with 10 co2 orings. On ebay. For the same as 1 at rap4.
However the rap4 one is a whole block, with a fixed pierce pin.
The seal is an Oring that goes around the nozzle in a Delta, but a flat washer that seals to the face on the rap4.
It depends on your 12grams. Some brands rip the Oring out after only a few cyls, others are ok. The faceseal type is far more durable, with a simpler replacement of the seal.
IF it doesn't give you trouble, you can stay with the stock type, but you have to open, clean and lube it with the rest of the pistol.
I just put a new block in a Delta68 sunday, I helped save an ebay victim. It was a block I made that takes Phantom pierce pins(faceseal type). A new cupseal and a shim spring added to the mainspring got it purring.
|All times are GMT -4. The time now is 07:25 AM.|
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO
© MCB Network LLC