Paintball

[Tanongi]

Recently I picked up an Automag RT Pro and am having problems finding a good fitting feedneck since the neck has been slightly cut down. Does anyone have any suggestions on what I can do, I'll post some pictures down below for reference.






So far I have tried:

1st Attempt - Spider Clamping Elbow

Result - It fits at first but as you move around it starts to "loosen" and move around, eventually falling off.

Damage - Scratched neck and teeth on elbow have been badly damaged

2nd Attempt - Spider Clamping Elbow w/ tape wrapped around neck. Cut the oring around the neck as it just got in the way.

Result - Fits, but same as before, it starts to loosen then fall off, the tape gets worn out nearly instantly and the hopper falls off.

Damage - Elbows teeth destroyed.

3rd Attempt - Brass Eagle Pocket Hopper Elbow

Results - lol, too big

My current attempts have been futile, I'm lusting to use this thing without the Revvy flying back and hitting me in the face while I'm running.

[Titus]

Hmm, that looks like a tight fit. I have an atomic elbow by APP new that I can sell you. Those fit very tight. It's not a clamping elbow.

[Ir0nExpress]

Looks like it was set up for a warp feed to me. I dont think anything involving an elbow would work with this, not with such a small area to work with. An elbow will clamp on intitially, but it cant possibily stand actual play.

Either warp feed or trade for a new body. Shouldnt be that hard to find. Just trade straight up with someone for it.