mcarterbrown.com

mcarterbrown.com (http://www.mcarterbrown.com/forums/)
-   Autocockers (http://www.mcarterbrown.com/forums/autocockers/)
-   -   WGP sniper prototype lever action autococker project with video (http://www.mcarterbrown.com/forums/autocockers/209826-wgp-sniper-prototype-lever-action-autococker-project-video.html)

arjames 08-01-2012 11:58 PM

WGP sniper prototype lever action autococker project with video
 
I have been tossing this idea around for awhile now. I think I am about ready to start fabricating some parts. Has anyone heard of this being done? I will post some pics of my progress if there is any interest in this thread.

sniperfan 08-02-2012 02:51 AM

Thought about it...my thought was to use the stock grip frame and pivot the lever through the safety hole- that should give you a really short lever stroke.

capt_cupcakes 08-02-2012 02:55 AM

I must see pics!!!

arjames 08-02-2012 04:19 AM

4 Attachment(s)
That was where I thought i would put it initially but after starting the mock up it seemed to be a better movement with the pivot off the reg where the pressure gauge would screw in. I have some 3/8 6061 aluminum to use and no special tools to cut it with just files, drill press, hack saw, angle grinder, and a vise. Here is what the mock up looks like and no I haven't figured out exactly how the pivot will pivot but the hex holes in the cp reg are a good point to start.

sniperfan 08-03-2012 12:19 AM

Interesting..A remote reg might give you a bt more room for the lever..

Have you ever watched a Biathalon rifle in action? The cocking stroke is so short...I always wanted to build a paintball gun styled after a Finewerkbau 300 match air rifle with that cocking motion.

arjames 08-03-2012 08:52 PM

The lever stroke is a lot shorter than most lever actions i just hope i can still grab the reg without interfering with the linkage. The Biathlon rifle is a slick setup for a bolt action have you seen the fx ranchero carbine it is similar and has a sweet stock too. Airguns of Arizona - FX Ranchero Carbine

arjames 08-03-2012 10:36 PM

16 Attachment(s)
Here is some ruff hack saw work and some holes. I left the arm wide so i can make sure its where i want it.

arjames 08-06-2012 03:57 AM

1 Attachment(s)
progress slow

arjames 08-10-2012 04:39 AM

1 Attachment(s)
did some more sanding and filing.

dundadun 08-10-2012 04:57 AM

Nice, I asked noxx for a similar lever action on a steaming phantom build(but it had two levers). Still waiting on him to just return the parts though.

Anyway for yours, look for an Asia extender that just uses a tiny air passage way. That should give you enough meat to add a pivot point


All times are GMT -4. The time now is 01:10 PM.

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO
© MCB Network LLC