-   Autocockers (
-   -   Mq2 karnivor help (

facelesskillah 01-20-2013 03:50 PM

Mq2 karnivor help
I just installed a mq2 valve in my karni and used it yesterday playing. It shot perfectly fine except that the fps is low on it and can't get it any higher. I have the little plastics white shim out and have the hpr at 290 psi "highest it will go before leaking"
I'm totally out of ideas. Please help

t0wer 01-20-2013 05:07 PM

what's your son?

facelesskillah 01-20-2013 05:41 PM

It's at 4 right now

t0wer 01-21-2013 01:40 AM

Try increasing son to 5ms.

facelesskillah 01-21-2013 10:38 AM

Ok will try that. I have an idea what that will so. But could you still tell me what it will so so I can be sure..

t0wer 01-22-2013 09:31 PM

it will keep the valve open a little longer increasing fps

All-Star Reject 01-23-2013 12:28 AM

Sounds like your valve is sticking, what kind of lube did you use. Most everyone including myself has the best luck with dow 33. It is not real necessary to polish the inside of the brass housing but it can help or relube or change the oring on the poppet (not the poppet face seal unless it is leaking).

facelesskillah 01-23-2013 05:49 PM

I used the Dow 33 from eclipse. And yup that's what I thought it will do thx

facelesskillah 01-31-2013 05:14 PM

Crap so my e2 board only goes up to 4ms on the "son.." is their any other tricks I can do to raise the fps?

All-Star Reject 02-01-2013 07:26 AM

Check that you don't have the screw that holds the poppet seal in too tight. It can cause the seal to spread out too much and cause it to drag. If you take it off make sure you use a drop of blue locktite when you screw it back on or it will come loose over time.

All times are GMT -4. The time now is 05:27 PM.

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO
© MCB Network LLC