Paintball

[juit]

here are some pics and tips if you open your G6R marker and wont get lost
because images are better than words
I hope this helps
please input some extra tips so we can make this a better thread

now lets get dirty!!

I found that a autococker valve removal tool is very handy to open the LPR in case that was over tighten
if you want to take the shrader valve this will be very handy too





Always remember when disassembling the LPR it is left hand (reverse) threaded.



The HPR section



you can take the trigger apart without opening the trigger frame, just watch out for the spring that can get cought on the micro switch



if you are planing to take aot the trigger frame IMO you will need to take out the board so you wont damage the noid & eye harness , for this you will need a small phillips screw driver and take those 3 screws to take out the board



take out the bolt, ram & ram back cap



now look for the ramsleeve screw




dont miss this oring from the trigger frame


open your eye plates and take out the eyes and ball detents






unscrew the feedneck and the 2 body screws

back section

front section


this is how the noid gasket has to be in place


in case you need to change the eye harness be careful not to press the harness
the is how it looks with out the noid section

[wildeman]

great pics. thanks.

[martix_agent]

did they change the lpr in 2012? mine does not have anything for my hex key to grab on the inside part of my lpr

[gamer565]

Originally Posted by martix_agent

did they change the lpr in 2012? mine does not have anything for my hex key to grab on the inside part of my lpr

Yes. You now have to use a crescent wrench, or normal open ended hex wrench to get it apart.

[martix_agent]

i figured as much, but it's worth asking about first.

[bigschank]

Nicely done! Big help!