|
             |
 |
|
| Brass Eagle Brass Eagle owners can hang out here |
 |
| | LinkBack | Thread Tools | Search this Thread |
10-13-2007, 11:42 AM
| #1 (permalink) |
| class clown  Join Date: Aug 2006
Posts: 663
| be raptor sputtering sometimes it will recock fully and be fine. most of the time, however, it sputters and won't recock. i have to then recock it. it happens so irregularly but more of the time than not. i assume it's either: 1. a problem with the sear 2. or the hammer spring is weak i've a full tank and gun is getting the pressure it needs and is properly lubed. the spring is pretty old and if i crank up the velocity, it does seem to lessen the problem SOME, but not much. so i'm really thinking it's the sear. but what to do? |
|  |
|
10-13-2007, 12:11 PM
| #2 (permalink) | |
| MCB Member  Join Date: Mar 2006 Location: Southern New Hampshire
Posts: 2,061
| Take the trigger frame off the marker and look at the top corner of the sear. if it's rounded off, replace it, or file it square. If it's still a sharp edge, your sear spring needs to be replaced, if not look at the striker, if the surface where the sear catches is worn down, you need to replace that.
__________________ A fart is a sh** without the mess! - George Carlin Quote:
| |
|
| |
|
10-13-2007, 02:38 PM
| #3 (permalink) | |
| Endearingly quirky  Join Date: Mar 2006 Location: Rocklin, CA
Posts: 4,030
 | The sear on Raptors is one of the weak points, and they're hard to come by. I've had success slightly deepening the notch on the hammer to give the sear a little more meat to bite into. Be careful not to deepen it too much, as you'll penetrate thru the wall. Also, the valve has a grub screw holding it in place. If it's in too far and the valve is oriented with the re-cock hole towards the bottom, it can choke off the re-cock gas. Remove your striker and look at the valve, if it's oriented this way, rotate it so the hole's at the top.
__________________ My money-pits Everybody loves me! If I hurt your feelings or otherwise offended you, click here. Quote:
| |
|
| |
|
10-13-2007, 03:13 PM
| #4 (permalink) |
| MCB Member  Join Date: Mar 2006 Location: HTown, TX
Posts: 1,700
| to add to Hurtcows comment, when I teched my friends raptor cause it would full auto and not recock I found that the valve lug was in to far and pinched on the valve stem holding the valve open some blue loctite fixed this problem.
__________________ Carter's Commando Texas division  Black Watch Scenario Paintball Team My SCP Feedback Ebay Feedback MCB Feedback |
| |
|
|
| Thread Tools | Search this Thread |
|
|
