|CCI Home of the Phantom Pump Gun|
| ||Thread Tools||Search this Thread|
|12-19-2012, 02:55 PM||#1 (permalink)|
Winter Project- With Questions
Sorry for the crap photo my Camera is broken so I used my phone.
ASP Center feed
ASP Roundhead body
ASP Detent Mod
ASP Hex TPC
SSC Tri-fluted Hammer
Wizbaa Oversized Power Tube
RTR Short spring guide
Madman old Spring kit
RTR Trigger Frame
Wevo pump rod
RTR Pump handle
CCI Reg (unfinished)
CCM 86 Frame
Dye Rail and On/off
Mill the RTR pump handle to add Delrin core
Cut down the Wevo pump to clear the RTR trigger screws
Anno Job -Tonsixers
Dye Lube Internals
Now for a question or two.
I had to drill out the TPC so it would slide on the oversized powertube and it is a bit rough inside. Now how can I polish the inside of it?
The second question is similar. The inside of the RTR trigger frame where the straight rod goes is rough as well. I am hoping the answer to the first question will fix the second.
|12-19-2012, 03:16 PM||#2 (permalink)|
US ARMY SIG CORPS
Join Date: Dec 2010
Location: Spanaway, Washington
The best way is to make a small sanding arbor.
Get a wood dowel just under the size of the hole, cut a slit on one end and wrap a strip of sandpaper around the dowel using the slit to hold the end.
Let me know if it is hard to understand and I will take a pic of one of my sanding sticks.
|12-19-2012, 03:19 PM||#3 (permalink)|
|12-19-2012, 07:19 PM||#4 (permalink)|
Next question I am going to have to take everything apart to send it in to get an anno job. I know this isn't a CCI question but many people put the Dye ASA on their markers. Anyone know how to completely take it apart? I have seen the Dye NT diagram but if anyone has any tips lmk.
Last edited by SilentNuke; 12-20-2012 at 12:56 AM.
|12-21-2012, 12:21 PM||#5 (permalink)|
****ing speak up Im deaf!
Inside the asa, the pin should go through and allen-key shaped hole. Unscrew and disassemble.
Team Brass Mafia - The Yorkie
|Thread Tools||Search this Thread|