|CCI Home of the Phantom Pump Gun|
| ||Thread Tools||Search this Thread|
|04-20-2013, 02:37 PM||#1 (permalink)|
Dropout, causes one piece feed to rise UP
so i just put a dropout changer on my phantom and i love it however when i use it with my once piece feed, the feed cap cause the feed to rise up. this causes a few problems and concerns such as its no longer a true stock class marker, and im worried about stripping the threads on the screw. What can i do to combat this issue, one idea i have is to sand down the feed cap but wouldn't this affect the actual gate inside the cap?
Thank you, and let me know if you need a picture
|04-21-2013, 07:12 AM||#3 (permalink)|
Walking without rhythm
This is what I did with mine...
The answer is yes you can cut/sand/ the feed cap and not worry. I had to go to a bit of an extreme...but it still worked perfectly.
Featuring Death on Facebook!
Fedaykin Paintball Productions on Facebook
Gravity League Ottawa on Facebook!
GLO Event 2 - 7 September 2014!
OXP Fall Tactical Tourney 19 October 2014
Stilgar's Events to Attend!
300z's Stock Class Classic 2!! 31 Aug 2014
|04-28-2013, 11:07 PM||#7 (permalink)|
"Electric paintball guns are a good way for kids to support their local field by buying so much extra paint."
Feedback : Click Here
|05-01-2013, 01:38 AM||#8 (permalink)|
You can grind all the way through the bottom of the CCI Feed cap in order for it to lay flush on top of a dropout.
You will need to cut the part of the feed gate ring between two of the 3 feed gate fingers too.
And you will need to use a piece of tape or some easy to remove glue to make sure the feed collar stays put if you jam a tube in there and pull it out cockeyed.
Other than needing to secure it down, it works 100 percent.
"I'll see it when I believe it"
|Thread Tools||Search this Thread|