-   CCM (
-   -   CCM S6 farting (

killjoywarrior 11-10-2012 10:24 AM

CCM S6 farting
So I relubed the reg and all that stuff, but to get a piece out I had to take out the pressure adjustment screw. Once I finished up and screwed the pressure adjustment screw in to around where I thought it was I aired it up and dry fired it a couple times, leading to some pretty obvious farting.

Is it related to the reg not being sweetspotted or what?

paintballedbackin88 11-10-2012 11:02 AM

The reg pressure might be low, especially if it wasn't farting previously and you haven't changed any springs.

ves206 11-10-2012 11:40 AM

Set reg screw in flush.. 2 turns in from flush. Should be close to 300psi input.. try thst

killjoywarrior 11-10-2012 01:50 PM

I use a CP reg, so I'm pretty sure it's different than the CCM reg.

I already know all about the tuning, I have to adjust pretty much everything since it wasn't that tuned when I got it.

PsychoDad 11-10-2012 02:38 PM

I tried a CP low pressure reg on mine, but it wouldn't put out enough psi. Make sure your reg is putting out at least 300.

Rotozip2 11-11-2012 01:49 AM

Cp regs are about three turns out from flush for 300 psi.

killjoywarrior 11-11-2012 09:54 AM

flush is all the way in or all the way out? I've always thought it was out

Ashton S 11-11-2012 10:36 AM

Manners count.

Flush is when the adjustment screw or IVG is flush with the bottom of the reg or the back of the body.

killjoywarrior 11-11-2012 11:09 AM

Thanks, I'll get it about three turns in then whenever I can get to a field in the spring I'll sweetspot it all the way then.

Talfuchre 11-11-2012 01:32 PM

Don't change the reg. CCM regs are great. Test the reg and make sure it is at about 300 PSI.

Put your IVG in about two turn in - and turn up the reg until farting stops - that usually does it.

Invest in building a reg tester.


All times are GMT -4. The time now is 05:12 AM.

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2016, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO
© MCB Network LLC