|CCM Chipley Machine|
| ||Thread Tools||Search this Thread|
|01-20-2013, 10:54 AM||#1 (permalink)|
CCM 6.5 Regulator
My 6.5 is leaking air out of the bottom cup channel next to the cap bolt.
I am going to replace the needle O-Ring to remedy this situation. Its weird, the O-Ring looks ok - but I figure - well its leaking - my O-Ring is not as fat as the T2 reg's needle ring as shown in the video.
What size is the O-Ring?
Also, should I put it the reg on a gauge or should I just try to sweet spot it like a Cocker?
|01-20-2013, 11:58 AM||#2 (permalink)|
Red - Black
Man - there HAS to be a manual on this....
Or - a video or something.
Oh... wait... in the stickies... all huge.... been there for years....
CCM Regulator Tech Video - YouTube
Do you mean it is leaking out of the cut out next to the adjustment screw? If so - replace the 'piston' o-ring on the regulator.
The specific size is in the manual above.
Pumpenstein - NSA National Champions
TF's MCB Trust.
Last edited by Talfuchre; 01-20-2013 at 12:10 PM.
|Thread Tools||Search this Thread|