|CCM Chipley Machine|
| ||Thread Tools||Search this Thread|
|06-17-2013, 09:25 PM||#1 (permalink)|
Join Date: Sep 2012
Pump Rod Measurement
Does any one have the measurement for the pump arm on a T2.. I had to replace one of mine. Now it seems like I can't get them even. You can feel it binding where it slides threw the lower tube when everything is tighten up.
|06-18-2013, 10:54 AM||#5 (permalink)|
Once the rods are assembled in the pump plate they are ground to length with a fixture.
Yes they are precise.
To just get it going I would tighten up on the rod that is the longest.
Then tighten the other screw till it binds then back it out till it unbinds. I would use loctite on the loose screw.
That's the easy fix.
Or send the pump plate with the rods and we can get it ground back to even.
“Do not yearn too much for a sword made by a famous smith. This is because even if you give a good man a sword worth ten thousand coppers, he will not be able to beat a hundred men each holding a spear worth a hundred coppers.” - Asakura Takakage Toshikage, 1462-1482
Whatever your hand finds to do, do it with your might; for there is no work, nor device, nor knowledge, nor wisdom, in the grave, where you go.
NEW STORE http://store.chipleymachine.com/
DOOR GUNNER handgun mounts for gunsafes.
|Thread Tools||Search this Thread|