mcarterbrown.com

mcarterbrown.com (http://www.mcarterbrown.com/forums/)
-   CCM (http://www.mcarterbrown.com/forums/ccm/)
-   -   Lower Tube Kit (http://www.mcarterbrown.com/forums/ccm/52521-lower-tube-kit.html)

rdogx78 09-29-2008 06:48 PM

Lower Tube Kit
 
So I've been looking for an upgrade to put into my wgp 2k3 sniper. A buddy told me about a CCM lower tube kit. I read about it in a somewhat short review on it. With a hefty cost of ~$70, what kind of benefits will I get? Is it a specific valve/spring setup for pumps? Will these internals basically transform my sniper into half a CCM series 5? Will it eliminate the burp with the spring setup? Any input is appreciated. I know I could just pick up some AKA or madman springs and monkey with them to fine tune the pump, but don't really have the time to do it.

Talfuchre 09-30-2008 06:45 PM

Check pumpenstein.com and there is a review of the internals on there - it is in an upgrades post.

TF

Pumpoison 09-30-2008 10:20 PM

Quote:

Originally Posted by rdogx78 (Post 535452)
So I've been looking for an upgrade to put into my wgp 2k3 sniper. A buddy told me about a CCM lower tube kit. I read about it in a somewhat short review on it. With a hefty cost of ~$70, what kind of benefits will I get? Is it a specific valve/spring setup for pumps? Will these internals basically transform my sniper into half a CCM series 5? Will it eliminate the burp with the spring setup? Any input is appreciated. I know I could just pick up some AKA or madman springs and monkey with them to fine tune the pump, but don't really have the time to do it.

I have CCM internals in my 2k5 superstock, I can make it burp or pffffffft with different pressures/ivg adjustments, mine runs healthily(but not efficiently) at 210-220 psi, shooting about 280 with the IVG about 1-1.5 turns in, the pump is butta smooth and light as a feather.

desertT1 09-30-2008 10:23 PM

Quote:

Originally Posted by Pumpoison (Post 537074)
I have CCM internals in my 2k5 superstock, I can make it burp or pffffffft with different pressures/ivg adjustments, mine runs healthily(but not efficiently) at 210-220 psi, shooting about 280 with the IVG about 1-1.5 turns in, the pump is butta smooth and light as a feather.

Can you run it with pneus as well? If so, does it run well?

Pumpoison 09-30-2008 10:37 PM

I don't see why you couldn't, but I've heard people don't like heavy hammers with pneu's, and the CCM hammer is a good bit heavier than the stock one.


All times are GMT -4. The time now is 10:33 AM.

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO
© MCB Network LLC