Paintball

[Shiba-Kun]

Originally Posted by CCmachinist

Just to let everybody know this tumbled finish is not going to be an optional finish we offer.It was something I have experimented with.

I hope you didn't have to spend a lot of time picking out media stuck in cracks and crevices.

[Zaneeboy]

Well I figure there's no need to start a new thread, I just shot my T2..wow. It's pretty quiet and I literally just put a hopper on and a tank in. I've done nothing to it outside of that. Gotta say I'm really impressed, the pump stroke is butter, as opposed to my S6 which had about 3 noticable different parts to the stroke if I pumped it as slow as possible, my T2 is quite literally one nice, smooth stroke. The return spring is actually really nice (saves me the hunt at Canadian Tire). I only have 2 little complaints/comments. The front of the pump handle is a bit scratched out of the box, not that I care, just something that caught my eye. When I screw the reg in all the way the macroline fitting doesn't match up with the underside of the frame, in fact it's facing straight ahead (so 180 degrees away from where I would like it). But it's nothing an O-ring can't fix.

[mtaylor]

Zanee, I think you can take the vertical ASA off and flip it around so the fitting is in the right spot.

[CCM CHICK]

Originally Posted by Zaneeboy

Well I figure there's no need to start a new thread, I just shot my T2..wow. It's pretty quiet and I literally just put a hopper on and a tank in. I've done nothing to it outside of that. Gotta say I'm really impressed, the pump stroke is butter, as opposed to my S6 which had about 3 noticable different parts to the stroke if I pumped it as slow as possible, my T2 is quite literally one nice, smooth stroke. The return spring is actually really nice (saves me the hunt at Canadian Tire). I only have 2 little complaints/comments. The front of the pump handle is a bit scratched out of the box, not that I care, just something that caught my eye. When I screw the reg in all the way the macroline fitting doesn't match up with the underside of the frame, in fact it's facing straight ahead (so 180 degrees away from where I would like it). But it's nothing an O-ring can't fix.

1) Take a picture of the pump handle and e-mail it to me.
2) with the fitting, get it set where you want it to be and once you air up your marker the reg halves will tighten up and keep the fitting in that spot.

Other than that glad you like it.

[Zaneeboy]

Originally Posted by CCM CHICK

1) Take a picture of the pump handle and e-mail it to me.
2) with the fitting, get it set where you want it to be and once you air up your marker the reg halves will tighten up and keep the fitting in that spot.

Other than that glad you like it.

I could honestly care less about the pump handle its a cosmetic scratch or two, in fact scuff would be a better term.

[Twigz]

Zaneeboy, take off the vert asa and spin it 180* then screw it on. It is just installed backwards right now.

[Zaneeboy]

Originally Posted by Twigz

Zaneeboy, take off the vert asa and spin it 180* then screw it on. It is just installed backwards right now.

figured that out...thanks though it did fix it...(why wouldn't it)