Custom

[AMG_Fan]

Okay, I have never had a chance to properly take apart a real autococker, only a trilogy. I am thinking about turing worr's blowback into a cocker.
Worrgames Worr Machine EG Paintball Gun - Blue at ActionVillage.com : Paintball
It already has the groove on the bottom that would need when you normally halfblock a cocker.

First question: what does the back of a cocker " front block"(piece holding the the LPR, 3 way and ram) look like?

I think I could use a cocker valve and spring.(cocker part outs aren't hard to find)
and this half-block striker for $20 on white wolf airsmithing
WGP marker pricing

Probably get an E1 frame for it and it seems to already have eyes drilled(if not eyes aren't the lynch pin of the project) It may be possible to use a blowback cut spring for the striker itself if the cocker main spring doesn't work. If the front block will attach to the front of that worr gun it may be possible.

Anyone know if this will work?

May be possible to use the stock bolt and a modified cocking rod (I have one laying around, no ****ing clue where it came from )

[super_stanchy]

i dont think swapping frames will work.... the frame has a "lump" on it that locks it into place......

as for the back of a front block... its just solid with a hole in the middle of it.

ummm good luck

[AMG_Fan]

Originally Posted by super_stanchy

i dont think swapping frames will work.... the frame has a "lump" on it that locks it into place......

as for the back of a front block... its just solid with a hole in the middle of it.

ummm good luck

Where is the lump?


Won't screw into an LPR hole? This piece:



EDIT: wonder if I could use a spyder frame with a bit of modification...

[AMG_Fan]

The E1 frame has it's own sear, and since it's using a cocker striker it SHOULD, in theory work better than say a spyder frame with a 3-way hot wired to the board.

[super_stanchy]

i ment the stock frame.... not the eframes

[AMG_Fan]

?
Worrgames Synergy Equalizer Paintball Gun at ActionVillage.com : Paintball

I only chose worr because it was most likely to have the same LPR screw. But a new screw can be machined to hold the front block onto, say a BE or VL gun.

Trying to get a "poo project" going.

[super_stanchy]

well that black one looks different than the blue one.....

hmmmm

go look at the 1st link you posted.... at the midpoint at the top of the frame it has a half circle that sticks out.....

[AMG_Fan]

Originally Posted by super_stanchy

well that black one looks different than the blue one.....

hmmmm

go look at the 1st link you posted.... at the midpoint at the top of the frame it has a half circle that sticks out.....

Yeah, I went back and looked, however it may be for looks(or it may not). Either way, like I said, I could machine the part that holds the front block on and adapt it to the countless other markers.