- - just an idea
|tymcneer ||05-19-2012 03:15 AM |
Just cut it to the length you want?
|ROBltxPB ||05-19-2012 03:18 AM |
|tymcneer ||05-19-2012 03:30 AM |
The front section of the Hammerhead could be cut to whatever length you desire. (I have a Hammerhead, but it may be an old one, so this may not be a valid point I am making. )
|Ziggymarley ||05-19-2012 03:20 PM |
A think a good machinist should be able to make that for you. See if Ryan at SSC might be able to
Make something for you when he starts taking new work. He's in the Airsmiths section.
|ROBltxPB ||05-20-2012 02:56 AM |
thanks ill look more into this.
|ROBltxPB ||05-20-2012 01:59 PM |
is ryan from ssc is not taking on new work i think anyone know of machinist that is not busy i dont want to stress anyone out?
|joedirt199 ||05-20-2012 03:36 PM |
jcurt is looking for work.
|tymcneer ||05-21-2012 12:05 AM |
There was actually a reason I answered this thread ;) I know a guy named Ty that has a few machines and is almost always looking for work.
|ROBltxPB ||05-21-2012 03:10 AM |
well TY how much would it cost to get something like this done, pm the info if you want.
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2016, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO
© MCB Network LLC