so I purchased 2 scepter launchers along with a punishers dual mount. The idea was only ever to use one on my milsig as in the pic.
However there are a few problems im facing...
1. the air inlet is not a standard size like you should see for a regular air fitting. it has been drilled out in some way to allow the punisher mount to work therefore i dont know how to het air to it.
2. How should I mount it to the gun. I have some basic machining abilities but not a ton.
3. How do I hook it to the main air supply for the gun. I have some hard line and was thinking about hardlining it in. any thoughts?
oh and a manual would be great as I think one of them is leaking :(
Feel free to post, pm, whatever works
Is it the same threading as a Vasa?
no im fairly certain its UNC 3/8 16TPI
If you have a drill press, couldn't you just make a block that does the same thing as the dual mount block, but is only a single block to mount just one scepter? It doesn't seem like it would be too difficult.
You can always go larger. Drill and tap for a 1/4 NPT and use a 1/4 NPT to 1/8 NPT reducer to get air to it.
ok I just got done machining the mount (pics will be up later). now its just the air.
definitely M8 threading in the back. I machined a reducer today for testing purposes until I decide if its worth drilling it out to 1/4 NPT. Long story short I am now waiting on Oring kits :bang: as they both have leaking issues.
Make a banjo bolt like the one that holds the front block to an Autococker and you can use the double mount.
|All times are GMT -4. The time now is 10:39 PM.|
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO
© MCB Network LLC