-   Custom Projects / Custom Questions (
-   -   ASA to stock adapter (

Skibbo 01-29-2013 10:12 PM

ASA to stock adapter
I came up with this design to use a CAR stock on my Hammer 7, but it'd work with any marker. It's currently incredibly long, I had to improvise some parts. You would need an air source for the marker to work, I would probably replace the gauge with a 45 elbow and a remote fitting.

Here's what it will look like (shows wrong ID buffer tube, but same idea)

I will drill and tap this for a 1/4-20 thread, but bottomed out so that air will not pass through, and I won't have to worry about thread tape.
Here's the prototype:

It has a 12 gram bucket changer fitting on the front, but a ASA to ASA would also work. It then has a remote line fitting to reduce from ASA to 1/4-20. Not shown is a rod going through the stock, capped off by a washer and cap nut to hold everything tight.

more pictures:

cap screw (I broke it by tightening it too much over the sharpened threaded rod...oops)

inner assembly:

washer caps off each end:

On the H7:

Bartman 01-29-2013 10:41 PM

not bad loooking at all, neat idea,

How do you like the hammer7


Skibbo 01-29-2013 10:48 PM


Originally Posted by Bartman (Post 2608374)
not bad loooking at all, neat idea,

How do you like the hammer7


It's nice. I have so many ideas that I may buy a second so I know I'll have a working one.

All times are GMT -4. The time now is 04:59 PM.

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO
© MCB Network LLC