mcarterbrown.com

mcarterbrown.com (http://www.mcarterbrown.com/forums/)
-   The Dead Zone (http://www.mcarterbrown.com/forums/dead-zone/)
-   -   thought process... eblade/cocker guys help! (http://www.mcarterbrown.com/forums/dead-zone/233437-thought-process-eblade-cocker-guys-help.html)

super_stanchy 05-14-2013 12:13 AM

thought process... eblade/cocker guys help!
 
i need to actuate a cocker 3way noid.....
but it will be a mech trigger


ie mech trigger, mid pull it cycles the 3way, which cycles the lpr/ram


possible? board wise.... its just the 3way activation, so on/off and dwell? i think?

i dont need a clapper noid, its not a cocker either, soooo dont worry about that haha


would it be possible?
mech trigger with electronic 3way noid to cycle the pneus??

SEFishy 05-14-2013 12:46 AM

well cocker boards dont use micro switchs so any object that passes through the boards sensor would trip the 3way with the clapper removed. Setting the board to classic mode should keep timing to a minimum. That way the 3way wont reverse until the object is moved

In theory a long adjustment screw installed through a trigger into the frame could be set to pass through the sensor. Using the screw length itself to fine tune timing

redlaser666 05-14-2013 12:56 AM

Actually depending on what you are actuating and when you need it to turn on and off a simple switch might just do what you need without a need for a board.
More details would help me give you a better answer or a simple circuit that will do what you need without complex or expensive electronics.

Good Luck!

aheg1220 05-14-2013 12:58 AM

Food for thought:

Put eyes in the lower tube, activated by the hammer. I'd guess this wouldn't be too hard with a T-board.

super_stanchy 05-14-2013 09:49 AM

Quote:

Originally Posted by aheg1220 (Post 2708280)
Food for thought:

Put eyes in the lower tube, activated by the hammer. I'd guess this wouldn't be too hard with a T-board.

legit idea....



cant tell the platform yet... too secretive

mech trigger (solid pull)
adding a cocker frontblock to it (lots of custom lol)
ram/lpr/noid

the ram will push the bolt back, then cycle forward and shoot



because i dont want to use the clapper, i have to get a little creative
i dont need ramping/burst/eyes

slow semi is fine by me!
actually full auto would be legit but not needed lol

i was thinking microswitch mounted in the trigger frame, behind the trigger
pull the trigger, marker cycles
trigger hits the activation point (microswitch gets hit) noid cycles the ram
repeat.


All times are GMT -4. The time now is 08:08 AM.

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO
© MCB Network LLC