-   The Dead Zone (
-   -   ICS on a non-ICS gun? (

super_stanchy 07-11-2013 10:18 AM

ICS on a non-ICS gun?
anybody ever done it?

anybody put an ICS in a gun with a standard backblock?

what was your solution?

my ICS isnt here yet... and neither is the gun its goin on, but im tryin to think ahead...

Its a karni ICS
Its a spanky Cobra Body/backblock

sooo anybody ever done it?

pics? thought process?

I really wanna use the stock backblock....

Im thinkin I can either thread the backblock for a screw, and inside the screw can be the ICS thread.....

desertT1 07-11-2013 10:59 AM

Bill (CCM) had a solution/product once upon a time. Can't remember what it was called though.

Aha! Found it. Happy reading: <- direct link to the post that the picture is in.

superman 07-11-2013 08:52 PM

sending you a message on facebook.

diesel_fireman2001 07-13-2013 04:32 PM

Did this a few yrs back. I threaded the back cocking rod hole, and made a plug that was threaded for it , then threaded the inside of the plug for the karni cocking rod

only pic I could find of it:

I probably still have that backblock floating around somewhere

ApoC_101 07-13-2013 04:43 PM

Was thinking of doing this to my S5RF, going to add a hidden second guide rod to the back block for sure though.

There are a couple ways to do custom ICS without modifying critical parts too much, my current favorite being a puller sleeve retained to unmodified back block with a screw, the sleeve fits inside the mainspring and requires a bored out IVG, and a purpose made cocking rod. Can be done the other way around too (sleeve on hammer). I prefer the first method because it makes disassembly and maintenance easier.

All times are GMT -4. The time now is 05:27 PM.

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO
© MCB Network LLC