mcarterbrown.com

mcarterbrown.com (http://www.mcarterbrown.com/forums/)
-   DIY Tech (http://www.mcarterbrown.com/forums/diy-tech/)
-   -   DIY TPX q-loader drum mag (http://www.mcarterbrown.com/forums/diy-tech/230439-diy-tpx-q-loader-drum-mag.html)

Wheeldogg 04-02-2013 09:25 PM

DIY TPX q-loader drum mag
 
This is how to make the Q-drum for a Tipx

Materials
-1 7 round tru-feed mag
-1 basic q-loader (cap and pod)
-some assorted needle files
-a Styrofoam cutter (i used "the styro wonder cutter)(dremel should also work)
-JB weld or other epoxy of your choice

Procedure
- Cut a hole in the bottom of the mag with the styrofoam cutter or a dremel


http://i1341.photobucket.com/albums/...ps33536154.jpg
http://i1341.photobucket.com/albums/...ps36c4be17.jpg

-file the hole until 100 percent flush with edges using a rounded file


http://i1341.photobucket.com/albums/...ps8201421e.jpg

-next cut the q-loader neck (not the black part) with a mag sized slit in the middle(leaving sides for support)

http://i1341.photobucket.com/albums/...ps8c856335.jpg

-File this down until the mag fits snugly but does not push the edges of the neck out(this is a fine line) It will fit over the black part inside the neck.

http://i1341.photobucket.com/albums/...ps4106a340.jpg
http://i1341.photobucket.com/albums/...ps2c92e64b.jpg
http://i1341.photobucket.com/albums/...ps7c583807.jpg

-Now cut another smaller channel in the back of the q-loader neck, allowing for the hump on the bottom of the mag to fit inside.

http://i1341.photobucket.com/albums/...ps8044e27a.jpg

-now it is time to glue
BE SURE THAT ALL MATING SURFACES ARE PERFECTLY ALIGNED BEFORE YOU GLUE!

put epoxy here

http://i1341.photobucket.com/albums/...ps6242afb8.jpg

then place the black tube and metal detent inside. Add epoxy to the outside of the black tube and around the edges of the Q-loader neck.

http://i1341.photobucket.com/albums/...psd88d391c.jpg

Allow to dry for 24 hours and then have a 111 round capacity tipx q-drum mag

http://i1341.photobucket.com/albums/...ps67cf1d2b.jpg
http://i1341.photobucket.com/albums/...ps0b417c54.jpg
http://i1341.photobucket.com/albums/...pse8e9c0ec.jpg

Rain-Man005 04-02-2013 10:29 PM

Wow, well done instructions. My only question is how well does it hold up to use?

Wheeldogg 04-02-2013 10:40 PM

no problems so far i have used it in games for about 5 weeks now.

Supergnome 04-01-2015 03:07 PM

Photos
 
Hi I know this is an old thread, but I'm looking at doing a q-loader Tipx mod and was wondering if anyone has the missing images from this post available.


All times are GMT -4. The time now is 01:37 PM.

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO
© MCB Network LLC