|DIY Tech Specific Tech How-To's for Customizing your Gun|
| ||Thread Tools||Search this Thread|
|04-02-2013, 10:25 PM||#1 (permalink)|
Join Date: Mar 2013
DIY TPX q-loader drum mag
This is how to make the Q-drum for a Tipx
-1 7 round tru-feed mag
-1 basic q-loader (cap and pod)
-some assorted needle files
-a Styrofoam cutter (i used "the styro wonder cutter)(dremel should also work)
-JB weld or other epoxy of your choice
- Cut a hole in the bottom of the mag with the styrofoam cutter or a dremel
-file the hole until 100 percent flush with edges using a rounded file
-next cut the q-loader neck (not the black part) with a mag sized slit in the middle(leaving sides for support)
-File this down until the mag fits snugly but does not push the edges of the neck out(this is a fine line) It will fit over the black part inside the neck.
-Now cut another smaller channel in the back of the q-loader neck, allowing for the hump on the bottom of the mag to fit inside.
-now it is time to glue
BE SURE THAT ALL MATING SURFACES ARE PERFECTLY ALIGNED BEFORE YOU GLUE!
put epoxy here
then place the black tube and metal detent inside. Add epoxy to the outside of the black tube and around the edges of the Q-loader neck.
Allow to dry for 24 hours and then have a 111 round capacity tipx q-drum mag
|10-25-2016, 02:20 PM||#6 (permalink)|
Join Date: Oct 2016
Hi can you upload all pictures again
|10-25-2016, 07:34 PM||#7 (permalink)|
|Thread Tools||Search this Thread|