| ||Thread Tools||Search this Thread|
|10-20-2012, 04:32 PM||#1 (permalink)|
Join Date: Mar 2011
Well after my second day of play I've had another issue pop up. And was having the same issue the first day but thought I was just half cocking the pump arm and not engaging the trigger.
Out of the box this trigger was lighter than my heavily modded ruger 10/22 trigger group. Even with the adjustment screw all the way out, the DSG was sub 1lb.
Today I was firing without pulling the trigger, just on the pump stroke. 2 out of every 4 or 5 pumps and the sear will not grab. I got home and have been working on it since. The sear has a bit of a concave appearance where it engages. And the hammer part that it grabs on looks visibly worn as well. Could be possible a weak spring. Or a mixture of all three contributing to the issue
As a band aid I ground down a small screw and placed the head under the sear spring to elevate it a millimeter or two. It will hopefully get me through at least tomorrow.
Did you have any suggestions? I'm pretty mechanically inclined with a garage full or tools. If I had to put money on it, it's that sear.
|10-20-2012, 06:18 PM||#2 (permalink)|
You can make the catch point on the sear a little smaller by grinding the back face of it further forward if you want to take the test a little further.
I have run into 3 sears that were improperly cut in 200. Usually its pretty obvious when they moved under the laser before completion.
It shouldn't be a weak spring, a pen spring will do the job.
|Thread Tools||Search this Thread|