-   Dye (
-   -   Hyper 3 problem. (

cybermaniac15 03-07-2012 02:37 AM

Hyper 3 problem.
My PM8's hyper 3 is showing at 100 psi when I turn the adjustment screw all the way in, what could that be? It isn't the tester cause it worked fine with my other hyper 3. (showed 0 when screw was all the way in)
It has the correct shim order, all new orings. Also has a new reg seat.

Nevit 03-07-2012 12:31 PM

Check the length of your adjustment screw that holds the reg seat, there are 3 different length's I believe.

Also, why does it matter? Set it to 190, do 4-5 turns out on the LPR and go chrono.

Viper0013 05-09-2012 12:52 AM

Check the length of your adjustment screw

All times are GMT -4. The time now is 09:17 PM.

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO
© MCB Network LLC