| ||Thread Tools||Search this Thread|
|09-20-2012, 07:51 PM||#1 (permalink)|
Join Date: Feb 2008
Gen E buzz when firing.
This is a new platform to me so I am somewhat befuddeled. Recently went thru a matrix lcd I purchased, it is bone stock. It hissed out the back when charged so I replaced the stem oring with a #10 ring because that is the nearest thing to a #9 I had. Lubricated uppers with dow33. On to the buzzing.....
Aside from hardly achieveing 200fps I would occasionally make a shot where the whole marker would make a reverberating buzz throughout the entire marker. Now this was not so much a sound as it is a sensation felt. It is not consistant other than it will do it maybe every 10 shots or so. I cant think of anything inside that would make this marker hum like hitting a hollow metal pipe at a far end. FSDO was appauling.
My areas of concern to bounce off of you guys is:
- a #10ring being too large.
- more lubricant or a change there of
- the charging of my regulator
An aside on the regulator: When I went through the cenetflag I noticed an oring stuck inside of the spring of the inlet pin. I cant find any diagrams of the regulator so I assumed it went into the perfectly fit hole ahead of the spring. Is this right period correct buffs?
|10-01-2012, 10:47 PM||#2 (permalink)|
go here-->Vintage Matrix - PB Legion
the best source for matrix info. period.
VIVA LE 6-PAK! team AGGRESIVE
my feed back http://www.mcarterbrown.com/forums/f...-feedback.html
|12-07-2012, 03:27 PM||#4 (permalink)|
Private Labels Only
Join Date: Nov 2010
|11-09-2013, 12:09 AM||#5 (permalink)|
Join Date: Dec 2010
Location: N. Phoenix
if I remember right the lcd's came with the image bolt so you should be fine with the 10 orings I run them on my LED's one has the image bolt the other the dye bolt which I think is the same anyhow. can tap a easy 17bps I
love my trix!
Never argue with an idiot. They drag you down to their level, then beat you with experience.
|Thread Tools||Search this Thread|