mcarterbrown.com

mcarterbrown.com (http://www.mcarterbrown.com/forums/)
-   Dye (http://www.mcarterbrown.com/forums/dye/)
-   -   07 PMR solenoid venting. (http://www.mcarterbrown.com/forums/dye/240501-07-pmr-solenoid-venting.html)

ogti9g9 08-22-2013 07:29 PM

07 PMR solenoid venting.
 
Alright, this pmr has been working well for a few years now. Replaced the battery/microswitch harness and since I did that, it's been venting from the noid.

It will hold enough pressure for the bolt to go forward half way in the breech and come back, and it won't leak. However, it won't send the ball down the barrel. When I raise the hpr, it starts venting from the noid area.

The higher input, the larger the vent.

What do I need to do?

lurch_man 10-25-2013 04:37 PM

open up the noid body and make sure the oring in there isn't pinched/damaged or anything.

Are you sure the "venting" is coming out of the noid?

I'd break into that and clean it up, if that doesn't solve it then I don't know what to tell ya.

dano_____ 10-25-2013 04:52 PM

I have had this problem with the bolt sail oring actually leaking. It makes it vent out if the noid. If it isn't that the. Check the 3 outside o rings around the firing end of the can. If none of those work then check that the noid isn't dirty/dry. Noid rings are tiny and easily damaged so messing with those is kind of a last resort thing.


All times are GMT -4. The time now is 12:34 AM.

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO
© MCB Network LLC