|
             |
 |
|
 |
| | LinkBack | Thread Tools | Search this Thread |
04-21-2009, 03:53 PM
| #1 (permalink) |
| Active Member Join Date: Mar 2009 Location: So Cal  | weird eye problem (weird for me atleast)
I have a rail that I put a UL frame on and when I turn it on it boots blue then turns solid green then I pull the trigger and it flashes green. I have cleaned the eyes, replaced the battery and nothing has changed. I have even unplugged the eyes and the same thing happens, does this mean that the board is bad or that the eyes need replacing?
__________________ Asians... building the railroad to the future! |
|  |
|
04-21-2009, 05:49 PM
| #2 (permalink) | |
| Seasoned Member  Join Date: Oct 2006 Location: Southgate, MI |
When the board blinks green it mean eye failure. It does it if you have no paint in your gun, basically if you are not using paint just putting your finger down the breech with trip the eyes again.
__________________ Quote:
| |
|
| |
|
04-22-2009, 08:59 AM
| #3 (permalink) |
| Post Whore  Join Date: May 2007 Location: South Jersey |
it sounds like the micro switch is being pressed on the trigger, causing it to go into setup mode, instead of firing. adjust out the trigger, so that there is more of a trigger pull. i haven't dealt with a rail or UL frame, but this has happened to me with a DM4 before.
|
|
| |
|
04-23-2009, 02:27 PM
| #5 (permalink) | |
| Seasoned Member Join Date: Oct 2006 Location: Southgate, MI |
Green is the eyes. No matter if they are unplugged or not it assumes they are there until the first trigger pull. Then the flashing green is eye failure. If it goes blue to green, check the dip switches and make sure it is 1up 2down if both are up it is in setup mode.
__________________ Quote:
| |
|
| |
|
|
| Thread Tools | Search this Thread |
|
|
