mcarterbrown.com

mcarterbrown.com (http://www.mcarterbrown.com/forums/)
-   Electronic (http://www.mcarterbrown.com/forums/electronic/)
-   -   Midblock Karnivor MQ project (http://www.mcarterbrown.com/forums/electronic/233424-midblock-karnivor-mq-project.html)

Donut SD 05-13-2013 10:42 PM

Midblock Karnivor MQ project
 
Was gonna put together an MQ karni, lost interest. It has one of those low cut bolts, which by the way the pin does not reach down into the lower tube. This was going to be a full MQ that I gave up on.

Features!
  • Milled body
  • Umarked bore kaner barrel
  • E1 (with a screw busted in it) grips are a bit battered
  • Low blow bolt
  • Bob long reg (If I remember right...)
  • stock feedneck

Problems!
  • Leaks from the tickler
  • I put a regular old valve in to see what held air. Everything but the tickler is fine
  • Plenty of old marks on it
  • Mostly mismatched...

Keep in mind this is an AS-IS sale, some things may leak now that didn't before. Asking for $350 shipped to your door.



Here it is.

http://i172.photobucket.com/albums/w...ps08527144.jpg

http://i172.photobucket.com/albums/w...psb6bc51e8.jpg

http://i172.photobucket.com/albums/w...psd4523de2.jpg

http://i172.photobucket.com/albums/w...psdd6cdfd0.jpg

http://i172.photobucket.com/albums/w...ps43a8fcfc.jpg

FlyingDonkey 05-13-2013 11:55 PM

So does this come with a full set of internals?

Donut SD 05-14-2013 12:00 AM

no internals. it's not milled to accept a pin to reach the hammer either. Offer away

Edit: what I mean is that it's not milled for the pin to go all the way to where your hammer would be, should you choose to not go the mq route. Just have that slot milled and get yourself a midblock lower tube kit and you're good to go.

Donut SD 05-15-2013 12:45 AM

bump i suppose

Donut SD 06-12-2013 06:25 PM

Remember you can offer up

Donut SD 06-24-2013 05:06 PM

bump

Donut SD 06-26-2013 09:12 PM

For sale :p offer up

Hanzo 06-27-2013 04:20 AM

Quote:

Originally Posted by Donut SD (Post 2743795)
For sale :p offer up

PM'd

also if you got a pic of that back end Id be much obliged.

Donut SD 06-27-2013 12:12 PM

Pending

Hanzo 06-27-2013 12:15 PM

thank you sir.


All times are GMT -4. The time now is 11:22 AM.

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2016, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO
© MCB Network LLC