Picatinny to Phantom adapter (Hammer7->Phantom)
Continuing form the Hammer 7 thread in the News section
I cam drew up an adapter that would allow the user to attach a phantom feedblock assembly to a picatinny rail (what the Hammer 7 has)
Here are two quick drawings.
Feel free to chime in with ideas since I have little to no machining experience.
It's drawn up as a 1"w x .5" h x 3.5" L then a 1" radius on the top to match the Phantom's OD.
I have the threaded hole (to secure the feedblock) going through the part. The thought is that the screw would prevent the assembly from shifting back and forth. Shouldn't have too much force on it.
also, maybe it doesn't even have to be that long. would that save cost?
This looks sweet, but how far up the rail does it go? Does it cover the screw to rotate the barrel? When I put the feed tube on mine I had to trim a fair bit off the "nose" of the feed block so I would have room to adjust the barrel screw. Otherwise you would have to remove the feedtube assembly when ever you wanted to switch to mag fed if that is your thing, which it probably is if you bought this marker lol.
Make it so!
It might. I picked 3.5 so it'd be the same length as the feedblock so it looked nicer to me.
I'd have to get a measurement of how close the screw hole is to the feedhole. if you had to take the nose off of the feedblock already then both would have to be shortened to fit.
Using McMaster's pricing and buying 6' of stock at a time, materials would be $1.50/part +shipping etc. for the 3.5" length.
If it does still work, and even better if it works with the speed wheel, I will be first in line to buy one.
Put the flats back on! you dont have any way to hold it all now.
Flats are back!
Oh, will this leave enough room for the breech screw?
not sure. guess it'd depend on how wide the screw head was.
|All times are GMT -4. The time now is 11:56 AM.|
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2016, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO
© MCB Network LLC