|New To The Sport Just started playing? Been playing for a while, but you have a question you should have asked years ago? Drop a line, we answer|
| ||Thread Tools||Search this Thread|
|09-21-2010, 02:32 PM||#11 (permalink)|
Join Date: May 2007
There may be a difference in price as well between the two.
Here is a shot of what I assume the OP is talking about:
This is me with my Automag, The parts to set the remote up are as follows:
1 90* 1/8" NPT Elbow (Otherwise the hose will stick out really far)
1 1/8" NPT QD
42" SS Braid Line (Male 1/8" NPT fittings on both ends)
2 Female QDs (Hooked to line)
1 Male QD (Hooked to ASA to allow differnt lines via QDs)
1 On/Off ASA with Bleed Valve (A bleed or slide check is a must with Automags, they can hold Pressure and make the line impossible to remove)
I reccomend getting a sleeve for your remote if you use the coiled type. I have a coiled line as well, and I don't like it as much as it likes to tangle, but I figure a sleeve would solve that. I am much more used to the braided hose remote lines anyway though.
|09-21-2010, 03:01 PM||#12 (permalink)|
Furries are EVERYWHERE :3
Join Date: Dec 2007
Location: Palatine IL
I would recommend getting a 90* 1/8 NPT fitting and putting it on the hose where it connects to the nipple
just like what's shown above, but with the bend on the other side of the quick-disconnect. that way you don't have to worry about clearance with the gun, and it'll only stick out the side about 1 1/2"
|Thread Tools||Search this Thread|