Paintball

[raptor69r]

Fellows,

I have a nice cherry pyre (071) and I decided to run two stabs on it, (I know it may be over kill) but like the male stab as a fore grip...
So what is the input / operating pressure for a dual stab set up?

What would be the PSI for the male? as I have not way to know the pressure for the internal stab?

Right now the male stab is set to 500psi, and it is shooting 245-265 ish, barrel 0.685 has widgets (sp?) and the paint is fresh the RVA is one turn in.

Any ideas or suggestions would be greatly appreciated

Thanks

Gabe

[splattttttt]

What I seem to be getting the best consistency a from was to turn both reg all the way in, then brought the integrated reg out 2.1/2 turns amd the inline 1/2.
With a T2 main spring, I'm able to adjust velocities from below 200fps to 290fps.
There's also this thread you can check out.

[raptor69r]

Jack,

Thanks for the response and for providing the link to more reading, will play with the pressures this weekend and see how it goes.

If I`m understanding this correctly UP the pressure on the Male stab to around 600-700PSI and UP the pressure on the integrated one as well, them start to lower pressure integrated/male until reaching desire FPS.
Now is there any adjustments to the RVA?
Or just use it to fine tuned once pressures are set?


Thanks

Gabe

[splattttttt]

right now with the RVA wit 2 turns in from flush, I'm maxing at about 200fps. Played at a field that uses RAP4 powder rounds and that was the limit.


I don't have a way to check the integrated reg's input pressure, so I'm keeping a difference of 2- 2,1/2 half turn apart from each reg.
Essentially, what you want is the inline higher by 2 turn, and the integrated at a lower psi.