| ||Thread Tools||Search this Thread|
|04-08-2013, 09:29 PM||#1 (permalink)|
1- fatty stabilizer pressure all over the place. starts at set pressure after shot then drifts to off the guage. next shot goes back to set and so on.
2-Blazer getting terrible velocity consistancy getting good results through other guns with same paint. paint sizes .688. just had a factory rebuild last year.
|04-10-2013, 10:38 AM||#2 (permalink)|
Join Date: Nov 2006
Replace the oring around the brass valve seat on the Fatty. The size is 010.
The Fatty spring will max out at 400 psi, So make sure the Fatty is set below 400 psi.
Check the velocity consistency.
Clean and oil the hammer area.
Then,, disable the LPR and cock it by hand.. and check the velocity consistency.
If it remains inconsistent, then the issue is not timing.
|Thread Tools||Search this Thread|