Paintball

[Redbeard the Pirate]

I just got a 2k Blazer in a trade, the day I got it I aired it up and it was working fine, I took it to go play this morning, attached the tank (while holding the trigger), let the trigger go, and now the pnuematics will move back and forth with the trigger pull, but no air down the barrel... like, it's cycling with the trigger pull, but not actually firing... where do I start?

It's an HP tank at ~850 psi out from the tank

Please help

[noxx55]

Bring it over Larren along with my 48ci tank and I will help you.

[dundadun]

I should probably know this, but why do you hold the trigger down when screwing in the tank?

[Maj Tom]

Doesn't matter if you do or not.

First guess the lpr is set too low.
After airing up cycle the marker and watch the hammer through the slot above the grip. When the bolt moves forward the hammer should be caught on the sear and not move. It does move the lpr needs to be turned up.

Pull and hold the trigger. Take an allen wrench and screw in the screw on the lpr (on the right side of the marker) in until you hear/see the hammer catch on the sear then turn 1/4-1/2 turn more then you're good to go.

[noxx55]

Originally Posted by Maj Tom

Doesn't matter if you do or not.

First guess the lpr is set too low.
After airing up cycle the marker and watch the hammer through the slot above the grip. When the bolt moves forward the hammer should be caught on the sear and not move. It does move the lpr needs to be turned up.

Pull and hold the trigger. Take an allen wrench and screw in the screw on the lpr (on the right side of the marker) in until you hear/see the hammer catch on the sear then turn 1/4-1/2 turn more then you're good to go.

That was my first guess as well. But it was actually the sear screw in the frame that comes out and activates the sear. Adjusted that and it works fine now. We had to disassemble my Blazer to figure out and wasted a little time shooting my Havoc towards the park. It's nice cause I can actually hit the park from my garage door.