mcarterbrown.com  

Reply
 
Thread Tools Search this Thread
Old 12-02-2013, 10:08 AM   #1 (permalink)
Rec Poster
 
Join Date: Mar 2012

CMI Thunderpig barrel tread?

Does anyone know what it is? I have one i am tinkering with and i can't place it using doc's giude. the thread in part is about 7/8 of an inch and they are 14tpi. For all i know it is not even the original body. it is a breach drop but i had to cut about an inch of to put a "standard nelson" dropout valve on it. i would also like to know if i could use phantom detent rings on it. right now i am just using electrical tape.
Thanks for any help you can give.
Istobla is offline   Reply With Quote
Old 01-03-2014, 04:00 PM   #2 (permalink)
.
 
The Inflicted's Avatar
 
Join Date: Sep 2008
Location: Chattanooga, TN

Not sure if this helps, but the Thunderpig's barrel threading is almost the same as the CMI Tusker and CMI/NPS Diablo and Diablo Deluxe.

I had all three guns for a while and if I remember correctly the Thunderpig could take the other guns' barrels but it would leave a slight gap after the threads.

The Inflicted is online now   Reply With Quote
Reply

  mcarterbrown.com » Paintball » The Armory » Pump Markers

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

Forum Jump


All times are GMT -4. The time now is 01:20 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO
© MCB Network LLC