Paintball

[Meph]

I've thought about it. Only instead I have a grinder. Wouldn't file, I prefer more power. Ahw ahw ahw! Only without the cocain. That or even possibly bending it. However there's no guarantee on accuracy of the bend.

That's a maybe. I'm going to wait until after christmas and contact Pun. I have a couple ideas on how to modify the pump handle itself to not only supply a new thread location, but also not needing to remake a whole new pump handle.

[Demonio]

If it didn't say CCI on the side, you couldn't tell what it is in Sheridan style.

Looks Hot though

[Cunha]

I think a grinder to clearance the pump arm would be your best bet..I had to send my dual rod undercocking kit back to punisher because the holes never got finished and were rough, it took like a month..for yours it may take longer. Just depends how long you want it to take.

Id grind it myself though .

[Meph]

I'll probably ignore modifying it and simply send it back to Pun. Handing over a couple ideas on how to fix it in a fast/easy method. But also a secure and clean method.

If a job is worth doing, it's worth doing right.....




...by illegal mexicans for sweatshop cheap labor!

[Meph]

Scratch that. It wasn't the bolt rod's hole being tapped in the wrong spot. The guide rods for the pump handle weren't making it square to the body. A little friendly twisting and elbow grease later and it's pumping fine.

Only thing left is to slap on an air source and try it out.

[Railgun]

Amazing looking marker. I particularly love the dovetail top rail that allows for stock feed in either direction or adding on a vertical hopper feed.

I've been toying around with the idea of making my own pump or semi once I get past doing a few mods. I'm going to use a variation of this dovetail design on the main block.