Paintball

[Havocx]

CCM offers a pre 2k mini kit. I love the feel of mine but I think it has some air flow issues so I would suggest the WWA as it has the built in vertical adapter. CCM requires you to thread your old one in and mine didn't fit so I had to order a new one (a hard job on its own)

[craltal]

Originally Posted by Havocx

CCM offers a pre 2k mini kit. I love the feel of mine but I think it has some air flow issues so I would suggest the WWA as it has the built in vertical adapter. CCM requires you to thread your old one in and mine didn't fit so I had to order a new one (a hard job on its own)

actually, they don't offer the mini kits anymore. WWA is the only one that I've found that offers the mini kit.

[Railgun]

FWIW I suspect that there's not many pump kits with rods sized for half blocked mini's. It really isn't that hard to make your own rod from 3/16 rod. Some stainless from a boat place or some cold rolled from a better hardware store. If you don't have fancy tools you can "turn" down the one end in prep for threading on the 8-32 using a hand drill and a file with some V blocking to support the rod and control the file so only the last little bit is reduced in size. On the other end just thread 10-32 right onto the plain rod.

So it would cost you the two dies to do the job and maybe a wrench to hold them.

[Walrus]

I had a place bookmarked that still had CCM Mini kits back when I was looking for one. Maybe you can see if they still have any. I had emailed and asked if they still had some in stock and got a fairly quick response.

http://www.flightlinepaintball.com/i...es/Page954.htm

Honestly, I would rather have had a WWA kit though because of the way it mounts and the way it looks.

[craltal]

Originally Posted by Railgun

FWIW I suspect that there's not many pump kits with rods sized for half blocked mini's. It really isn't that hard to make your own rod from 3/16 rod. Some stainless from a boat place or some cold rolled from a better hardware store. If you don't have fancy tools you can "turn" down the one end in prep for threading on the 8-32 using a hand drill and a file with some V blocking to support the rod and control the file so only the last little bit is reduced in size. On the other end just thread 10-32 right onto the plain rod.

So it would cost you the two dies to do the job and maybe a wrench to hold them.

i know, but WWA is willing to custom cut and thread it for me which saves me the time and effort
and it'd be cheaper than the CCM one Walrus found (thanks for the option btw)

[craltal]

Originally Posted by Walrus

I had a place bookmarked that still had CCM Mini kits back when I was looking for one. Maybe you can see if they still have any. I had emailed and asked if they still had some in stock and got a fairly quick response.

http://www.flightlinepaintball.com/i...es/Page954.htm

Honestly, I would rather have had a WWA kit though because of the way it mounts and the way it looks.

I've tried emailing them and keep getting a permanent email failure. I guess I'll try calling sometime and see what's up