|Rare and Old Come across a gun older than 1994? There is an evil cult always on the look out for these. Post your finds!|
| ||Thread Tools||Search this Thread|
|10-30-2012, 01:45 AM||#12 (permalink)|
Join Date: Aug 2011
|10-30-2012, 03:29 AM||#14 (permalink)|
no, I'M sorry
Join Date: Oct 2006
you can't defy physics, if smart parts pulled it off then they would be selling that magic box for more than just paintball.
pile of poo, HARD MODE, automag pistol---S.P.E.W.II---What if this hurts me?---No, I'M sorry.---Semiautomatic Nelspot 007!---Decay of Nations 4
Camp Pendleton meetup 2010---Watch me fail at pump!---Clareball 2010 vid!---MCB Stock Class Meet!---HELMETCAM!
|10-31-2012, 09:31 AM||#15 (permalink)|
Join Date: Jan 2012
No I take it back, it does add range by defying physics! How? Well smart parts was up front and honest about this one, it's magic! Smart parts is a magical company with aptitude for sorcery and alchemy far beyond us. They magically made mags shoot further by laughing in the face of sir isac, and they magically used their alchemical skill to turn blank paper into patents that they did not really hold in entirety. *With smart parts anything in the realm of the impossible is now possible*!
*your results may vary*
|11-02-2012, 10:46 PM||#16 (permalink)|
One in the Pipe!
|11-03-2012, 03:55 PM||#17 (permalink)|
So I spent all morning and found the famous PBN thread:
Gets good at pg 31:
Smart Parts files gas-through-gripframe patent (Mini affected?) - Page 31
The Magic Box gets brought up at page 36:
Smart Parts files gas-through-gripframe patent (Mini affected?) - Page 36
Doc pops in at page 43,46:
Smart Parts files gas-through-gripframe patent (Mini affected?) - Page 43
Smart Parts files gas-through-gripframe patent (Mini affected?) - Page 46
Tom pops in at page 48:
A quote from Doc in that thread
".... It's a hollow tube fitted to the side of the 'Mag dump chamber, that increases the total volume roughly 20%. This had the effect of lowering the operating pressure from around 400 psi to right around 350 psi.
This, in turn, reduced gas efficiency (shots per tank) by about ten percent.
That's it. That's the only thing it did.
The "made for" SmartMags, simply had two holes drilled on either side of the dump chamber inlet, that roughly approximated the additionbal volume of the external tube.
Again, it didn't do anything. Every claimed aspect was entirely false.
Interestingly enough, another company called Foxhunters, made a version with a smaller chamber. This increased the op pressure from 400 to about 450 psi, and increased gas efficiency by about that same ten percent.
The problem here was that it also made the trigger pull harder (more pressure on both the on-off valve pin, and the bolt and thus the sear) and accellerated sear wear.
My Custom Guns: http://smg.photobucket.com/albums/v6...Custom%20Guns/
WTB: RT (Robtown) Valve/hammer kit for 04 Excalibur
WTB: Racegun autocockers
Last edited by diesel_fireman2001; 11-03-2012 at 03:58 PM.
|Thread Tools||Search this Thread|