Paintball

[ironchef97]

Yep balls only drop out when you try to spin cock it, normal cocking isn't a problem at all since the feed tube is lower than the barrel.

[llaw999]

Ironchef, you having a hard time with the changer? Kinda tough to get a good 12 gram seal with the instant pierce.

I get about a 1/2 second to a second of hissing before a complete seal. Guess it's not too bad.

[ironchef97]

I don't have a problem at all but I have an older Nelspot piercing pin with a tiny piercing pin, the CCI pins have a larger cone and it ends up you have to turn the knob more before you seal the 12gram.

[skipjack289]

Originally Posted by llaw999

Ironchef, you having a hard time with the changer? Kinda tough to get a good 12 gram seal with the instant pierce.

I get about a 1/2 second to a second of hissing before a complete seal. Guess it's not too bad.

If you had the Fasst changer extended beyond the barrel, you would have more of your hand wrapped around the changer, have a better grip, and produce more torque with the hand, than with your fingers.

As it is, you may want to have 4 holes @3,6,9,12 drilled and use an Allen wrench to stick in the holes to produce the amount of torque needed to cleanly pierce the 12.

[ironchef97]

Originally Posted by skipjack289

If you had the Fasst changer extended beyond the barrel, you would have more of your hand wrapped around the changer, have a better grip, and produce more torque with the hand, than with your fingers.

As it is, you may want to have 4 holes @3,6,9,12 drilled and use an Allen wrench to stick in the holes to produce the amount of torque needed to cleanly pierce the 12.

Or, have the holes drilled to the diameter of a 12-gram's neck, and use a 12-gram to provide extra torque instead of allen keys!

[llaw999]

I might have the fast changer extend pass the barrel by 1/2 an inch on the next build but I really like the even look.

Or I could just find a nelspot pierce pin. They're the same threading as the CCI pin right?

[llaw999]

Ironchef, I'm guessing you're using the nelspot drop-out pierce pin?

[llaw999]

I doubled the seal on the cci pierce pin and shortened the pin by a lot. I think that should act more like your nelspot pin now. Just need my gun back to try it out!

[ironchef97]

Originally Posted by taco

Did you put a clear coat on the chplnstone stock looks great

Yea it's a clear coat, hows your lever doing?

[llaw999]

Rick has it lol. That drop messed it up proper. The set screw on the lever is stripped. He's working on it this week.