mcarterbrown.com  

Showing results 1 to 40 of 44
Search took 0.02 seconds.
Search: Posts Made By: Bill
Forum: WTB 04-23-2014, 06:00 AM
Replies: 10
Views: 219
Posted By Bill
Is that the part that kicks the tank up at about...

Is that the part that kicks the tank up at about 15 degrees? I may have one.
Forum: Eclipse 01-20-2013, 10:41 AM
Replies: 6
Views: 806
Posted By Bill
If you still are in need, try an EGO7/8...

If you still are in need, try an EGO7/8 solenoid/manifold combo. Works fine. Just raise your dwell to 13.
Forum: Eclipse 01-20-2013, 10:40 AM
Replies: 5
Views: 495
Posted By Bill
The Cure4 will have velocity fluctuations with an...

The Cure4 will have velocity fluctuations with an 05/06 EGO. I would suggest the Cure3.
Forum: Eclipse 09-18-2012, 05:34 AM
Replies: 5
Views: 308
Posted By Bill
Contact Badlands in Toronto. If anyone in CA can...

Contact Badlands in Toronto. If anyone in CA can get one, it is Trevor.
Forum: Eclipse 09-18-2012, 05:31 AM
Replies: 7
Views: 803
Posted By Bill
The programming on the EGO8 dwell resets at 3ms....

The programming on the EGO8 dwell resets at 3ms. I wouldnt go below 12.5 or you could suffer paint breakage.
Forum: Eclipse 09-18-2012, 05:30 AM
Replies: 2
Views: 339
Posted By Bill
When you changed out the bolt did you have to...

When you changed out the bolt did you have to adjust the velocity? If so, the dwell could be set to high. I would try dropping the dwell a few.
Forum: Eclipse 08-01-2012, 10:37 PM
Replies: 11
Views: 1,376
Posted By Bill
The common issues people have that will cause the...

The common issues people have that will cause the Etek to leak from the solenoid area and what I would suggest...
- Swap out the #11 oring which is the most rear black oring on the rammer (see page...
Forum: Eclipse 08-01-2012, 10:34 PM
Replies: 8
Views: 331
Posted By Bill
I would suggest the following steps... - Try a...

I would suggest the following steps...
- Try a new Energy, Duracell or Energizer battery. The gun needs a good amount of power to run the marker properly. A lessor brand of battery may read fully...
Forum: Eclipse 07-25-2012, 09:15 PM
Replies: 2
Views: 401
Posted By Bill
Any chance you put the pin in upside down? The...

Any chance you put the pin in upside down? The vent hole in the side of the bolt should be facing down. If it is rotated 180 degrees the air coming from the valve will not flow thru the bolt. If this...
Forum: Eclipse 07-19-2012, 10:24 AM
Replies: 1
Views: 373
Posted By Bill
Yes, all eclipse eyes will work in an Etek.

Yes, all eclipse eyes will work in an Etek.
Forum: Eclipse 05-03-2012, 10:07 PM
Replies: 7
Views: 499
Posted By Bill
Star framed ETEK2.

Star framed ETEK2.
Forum: Eclipse 05-03-2012, 10:06 PM
Replies: 4
Views: 279
Posted By Bill
Ive owned a few of the Hurra-EGOs.

Ive owned a few of the Hurra-EGOs.
Forum: Eclipse 04-28-2012, 09:46 PM
Replies: 4
Views: 279
Posted By Bill
Rear QEV diaphragm.

Rear QEV diaphragm.
Forum: Ask The Experts 04-28-2012, 08:01 PM
Replies: 0
Views: 136
Posted By Bill
War Sensor e-grip...

Any idea which markers this will fit? I came across it when I was cleaning out my back room. Someone says it will fit the Zues. Any truth? I also posted in the Misc gun forum...
...
Forum: Miscellaneous Markers 04-28-2012, 07:59 PM
Replies: 4
Views: 424
Posted By Bill
War Sensor electronic frame...

I was digging thru my back room and came across this. Any idea which markers it fits? I was told it may also fit the Zues series. Any truth?...
Forum: WTB 03-04-2012, 10:55 AM
Replies: 8
Views: 293
Posted By Bill
Interested in a new e-grip cheap? Email me:...

Interested in a new e-grip cheap? Email me: paintballsupply@aol.com
Forum: Misc Paintball Items 06-17-2011, 03:06 PM
Replies: 56
Views: 4,092
Posted By Bill
124 and 217 are MINE! lol

124 and 217 are MINE! lol
Forum: Ask The Experts 06-15-2011, 03:50 PM
Replies: 4
Views: 203
Posted By Bill
2000 centerfeed with a blue ANS front kit and a...

2000 centerfeed with a blue ANS front kit and a System X drop forward.
Forum: Ask The Experts 06-15-2011, 03:39 PM
Replies: 1
Views: 194
Posted By Bill
Who makes this?

http://i94.photobucket.com/albums/l109/pbss1/Timmy_15_degree.jpg

15 degree front reg mount for a BL Intimidator.

Worth $?
Forum: WTB 06-09-2011, 03:28 AM
Replies: 7
Views: 132
Posted By Bill
I may have a new Messiah. I will check for you...

I may have a new Messiah. I will check for you tomorrow.
Forum: WTB 10-30-2010, 11:40 AM
Replies: 2
Views: 156
Posted By Bill
I have a new, never used 08 dust black tip for...

I have a new, never used 08 dust black tip for $25 shipped.
email: paintballsupply@aol.com if interested.
Forum: WTB 10-30-2010, 11:38 AM
Replies: 5
Views: 182
Posted By Bill
What are you looking to spend?

What are you looking to spend?
Forum: WTB 12-30-2009, 05:14 AM
Replies: 14
Views: 358
Posted By Bill
I have 2 NIB Halo TSA's. Color: Clear. $25ea plus...

I have 2 NIB Halo TSA's. Color: Clear. $25ea plus shipping.
Forum: WTB 12-09-2009, 09:34 PM
Replies: 5
Views: 157
Posted By Bill
I have some Rat valves by Shocktech. There is no...

I have some Rat valves by Shocktech. There is no packaging but they are new. $8each
Forum: WTB 11-07-2009, 11:52 AM
Replies: 15
Views: 452
Posted By Bill
I have a new in box X-Valve. What is the going...

I have a new in box X-Valve. What is the going price?
Forum: Electronic 11-05-2009, 07:42 PM
Replies: 36
Views: 2,803
Posted By Bill
PM me your lowest. Very interested.

PM me your lowest. Very interested.
Forum: Electronic 11-01-2009, 02:33 PM
Replies: 36
Views: 2,803
Posted By Bill
Still available?

Still available?
Forum: Electronic 10-24-2009, 09:59 AM
Replies: 6
Views: 886
Posted By Bill
Taking trades. Offer up!

Taking trades. Offer up!
Forum: WTB 10-17-2009, 11:25 AM
Replies: 3
Views: 206
Posted By Bill
Still looking? I just posted one in the mech...

Still looking? I just posted one in the mech section...
http://www.mcarterbrown.com/forums/electronic/95738-nexus-cocker.html
Forum: Electronic 10-17-2009, 11:23 AM
Replies: 6
Views: 886
Posted By Bill
Nexus cocker

For sale:
http://i94.photobucket.com/albums/l109/pbss1/PICT00012-1.jpg
Nexus E-cocker with all the goodies...
Matching UL
Nexus bolt
Nexus internals
Nexus front block
etc..

I am looking for...
Forum: Eclipse 04-26-2009, 09:35 PM
Replies: 3
Views: 600
Posted By Bill
PE now puts out a back kit that is $79. It comes...

PE now puts out a back kit that is $79. It comes with a 685 and a 688 to match your 693 factory one. I have them in black, white, blue, red and brown. Give the shop a call tomorrow if interested.
Forum: Eclipse 04-22-2009, 12:32 AM
Replies: 2
Views: 1,730
Posted By Bill
You can up your dwell slightly to 14 and put your...

You can up your dwell slightly to 14 and put your LPR at one turn in. You have to face facts, the EGO series markers are not quiet guns.

You can try a 16" UL or All American barrel. They are the...
Forum: Eclipse 04-07-2009, 06:29 AM
Replies: 31
Views: 2,227
Posted By Bill
VLocity is my hopper of choice. Fast, reliable...

VLocity is my hopper of choice. Fast, reliable and compact!

Buy the tank you feel most comfortable with.
Forum: Eclipse 03-09-2009, 06:23 AM
Replies: 7
Views: 1,918
Posted By Bill
Have you ever taken the rammer sleeve out of the...

Have you ever taken the rammer sleeve out of the gun? If so, you may have put it in upside down. :)

Do you have the star frame w/QEV setup? Diaphragm in the QEV may need to be replaced.
Forum: Eclipse 02-13-2009, 06:19 AM
Replies: 2
Views: 472
Posted By Bill
A stock board is $80 shipped although you can...

A stock board is $80 shipped although you can find them used floating around for under $50. PM me if interested.
Forum: Eclipse 12-19-2008, 05:28 AM
Replies: 18
Views: 1,480
Posted By Bill
I use one. Black with Lagoon parts. Beautiful...

I use one. Black with Lagoon parts. Beautiful marker!
Forum: Mechanical Semi-Autos 12-10-2008, 06:42 PM
Replies: 6
Views: 534
Posted By Bill
twister Autococker body

sold to PWpaintball
Forum: WTB 12-10-2008, 06:40 PM
Replies: 12
Views: 567
Posted By Bill
nevermind. sorry

nevermind. sorry
Forum: WTB 12-10-2008, 06:36 PM
Replies: 10
Views: 422
Posted By Bill
http://i94.photobucket.com/albums/l109/pbss1/PICT0...

http://i94.photobucket.com/albums/l109/pbss1/PICT0001-4.jpg

Make an offer. Body, front block, ASA and rear block.

gun is in decent shape. Has some small scratches on the other side next to the...
Forum: Eclipse 09-15-2008, 08:01 AM
Replies: 3
Views: 737
Posted By Bill
The EGO5/6 and Etek grips will fit with some...

The EGO5/6 and Etek grips will fit with some modifications. They do not have the rounded out area for the sear solenoid. You will have to grind out the inside of the grip to fit them.
Showing results 1 to 40 of 44

 
Forum Jump

All times are GMT -4. The time now is 12:38 AM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO
© MCB Network LLC