- - KP-2 Parts
|Dennis ||01-19-2012 06:55 PM |
I am looking to find a few screws for a KP-2 project I am working on. The screws/parts in question happen to be the rod that lets the bolt engage the hammer, and the 2 screws and nut that are used to hold the body of the marker to the stock. I have attached an image below containing the parts highlighted on the K-2/KP-2 diagram and a picture of the parts in question. Thanks in advance!
|Dennis ||01-19-2012 07:04 PM |
Wow that was quick!:bowdown Thanks again!
|russc ||01-19-2012 07:08 PM |
The bolt lug should be a standard hardware store screw...not sure of the thread, though.
|longstar550 ||01-19-2012 10:24 PM |
threads should be 6/32
|Stilgar ||01-19-2012 10:27 PM |
Thanks! I also needed a bolt lug!
|sniper42 ||01-20-2012 03:59 AM |
The cocking lug threads can vary. Mine personally is 8-32 but there are some that are 6-32 as well. All of those screws can be had for cheap at your local hardware store. The pringle nut might be harder to come by though.
|Dennis ||01-21-2012 02:06 PM |
Here, I figured I would post up some pics of the project I am working on. I haven't really started yet. I have only cleaned off the dirt and gunk it collected from sitting in a barn for about 15 years. It also looks like I am going to have to fix the lower tube where the action fastener screw assembly attaches the body to the stock.
|All times are GMT -4. The time now is 03:45 AM. || |
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO
© MCB Network LLC