|
             |
 |
|
 |
| | LinkBack | Thread Tools | Search this Thread |
03-04-2012, 05:21 PM
| #1 (permalink) |
| MCB Member  Join Date: Jan 2012 Location: around the middle of Virginia  | Looking for a PGP parts diagram.
I recently acquired what looks like most of a PGP. Does anyone have a parts drawing of this fine marker? I would like to figure out what I am missing and get it back in good working order again. Thanks |
|  |
|
03-04-2012, 06:03 PM
| #2 (permalink) | |
| Bolt Action/Pistol Player  Join Date: Mar 2009 Location: Pascoag, Rhode Island  | 
__________________   S.C.A.R. - The Simulated Combat Association of Rhode Island - S.C.A.R. on Facebook - My MCB Feedback - Meet "The Devil's Brass" Quote:
| |
| |
|
03-04-2012, 06:58 PM
| #3 (permalink) |
| MCB Member Join Date: Jan 2012 Location: around the middle of Virginia |
That is great now I just need to figure out where to find the missing parts. Looks like I am only missing 2 things, the pin from the striker assembly and one of the bolt detent balls. I will probably want to replace all the o-rings and seals while I am at it Should be a fun unit to play with this spring. |
|
| |
|
03-04-2012, 07:15 PM
| #4 (permalink) | ||
| MCB Member  Join Date: Jun 2008 Location: looking through a hole in grandmothers wooden leg |
The pin from the hammer is just a short roll pin you can get at most hardware stores(might have to cut one form there shorter) The ball bearing is a 1/4 ball bearing, you can get these at walmart look at the sling shot ammo.
__________________ 4 out of 5 voices in my head say i'm ok Quote:
Quote:
Stuff I want or need evenually want to buy red pump handle Nelson, Tippmann, Dye, Angle, Spyder stuff | ||
|
| |
|
03-12-2012, 10:47 AM
| #5 (permalink) |
| MCB Member Join Date: Jan 2012 Location: around the middle of Virginia |
The pin for the hammer was in the bag as well not sure why they took it out. Put it all together minus the ball bearings in the bolt and put the gas to it this morning and it works great with no leaks. I will change out all the seals anyway because it has sat so long and polish the insides to keep it smooth. Any suggestions for wahto to do with the outside? Polish? Plate? Repaint? or just leave it as it is with that well worn played with a lot look?
|
|
| |
|
|
| Thread Tools | Search this Thread |
|
|
