|joedirt199 ||09-03-2012 09:03 PM |
i have had bad luck with the stain and finish in one. always seems to streak or not apply smoothly for a natural stain look. you might have better luck but it is a pain to start over if the finish is not what you expected.
|Donut SD ||09-03-2012 09:10 PM |
Funny you mention that. I'm happy with the outcome so far. I also have a finish only varnish so I can have that extra matte lustre.
|mailmanmike ||09-04-2012 10:14 PM |
|SockMonkey ||09-05-2012 10:07 AM |
is that one of those reproductions? I have one that I haven't finished yet, and I kinda like that finish.
|SockMonkey ||09-05-2012 02:14 PM |
And did you make sure everything fix properly before applying a finish. Mine was a bit tight. I had to take sand paper and use an old PGP body to open the trough the valve tube sits in. And there were a few other things.
|Donut SD ||09-05-2012 03:50 PM |
So far everything fits. I took off the safety on the rifle because I was too lazy to try and cut out a spot for the levers. Everything fits, needed minimal adjustments. My only snag is that I'm going to have to make the screw hole a bit deeper or get a longers screw. It won't catch the body of the lower tube. Other than that Everything is prim and nice :)
Oh yeah I'm looking for a nice trigger guard. Any ideas guys?
|ksciupider ||09-05-2012 05:29 PM |
Brass spoon? bend and shaped?
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO
© MCB Network LLC