pmi-2 not cocking ?

Myke · 08-14-2006, 07:36 PM

...

Crash · 08-14-2006, 07:50 PM

Well.....
1) does it have an RVA built into the ASA?
2)have you had the ASA off?
It could be the spring is shimmed/rva is too far in and stopping the hammer from catching on the sear.
3)have you checked the sear or the catch on the hammer for damage?
As for the screws I would try the local hardware store if you want them. I ran my SB for years without them, just rember to keep the frame screw tight! Hope this helps.

WilD · 08-15-2006, 09:55 AM

Quote:

Originally Posted by Crash

Well.....
As for the screws I would try the local hardware store if you want them. I ran my SB for years without them, just rember to keep the frame screw tight! Hope this helps.

I definitely recommend you replace the screws sooner rather than later. If the ASA moves around excessively, which it likely will, it will put added strain on the rigid gasline. The gasline will eventualy develope a leak, and that is a pita to fix.

08-14-2006, 07:36 PM	#1 (permalink)
Myke Newbie Join Date: Jul 2006	... Last edited by Myke; 05-22-2007 at 12:16 AM.

08-14-2006, 07:50 PM	#2 (permalink)
Crash Post Whore Join Date: Mar 2006 Location: North East Texas	Well..... 1) does it have an RVA built into the ASA? 2)have you had the ASA off? It could be the spring is shimmed/rva is too far in and stopping the hammer from catching on the sear. 3)have you checked the sear or the catch on the hammer for damage? As for the screws I would try the local hardware store if you want them. I ran my SB for years without them, just rember to keep the frame screw tight! Hope this helps. __________________ Later, John My FS Listing Misc bits- My feed back: http://www.mcarterbrown.com/forums/s...ead.php?t=1021 Carter's Commando Texas Division: http://www.mcarterbrown.com/forums/c...-division.html

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search