Paintball

[dauntless15]

has anyone done this ?? i want to use my pgp but the ball berings get anoything . and when i hold it double handed the shot pushes the bolt back and its anoying . so i was thinking to put a small nut or somthign around the pump arm and brazed to the body , and a spring between that and the plastic pump . so thers no blow back lol .

[pizzaluvr]

You'd have to put a pretty hard spring. PGP's aren't the smoothest.

[Stuffy]

Might work. Try it, and report back to us to see if it works. :thumbp:

[dauntless15]

well to mount the nut , do i use jb weld ? whould that work as a test ? do i have to jb weld it to the brass or can the paint be on it ? and my pgp is extreamly smooth

[pizzaluvr]

Use superglue to test it out. It's not that hard to knock it off if it doesn't work. Then put some JB weld on when you finalize it.

[dauntless15]

so should i use a phantom socking spring ? or sould i take like 10 pen springs lol

[pizzaluvr]

Experiment with different ones. the Phantom stock spring would probably work. Remember you can easily make it tougher or looser by moving the nut.

[dauntless15]

well thats on a phantom . i was just gonn a put a sleeve for the pump rod to go thure and the spring sets up next to . i whould have to thread the pump rod if i wanetd to do that

[pizzaluvr]

No I mean you can adjust the strength of it by moving the nut. Once you JB weld it, it's in place. Sorry if I misunderstand you, I can't understand half of the stuff your saying.

[dauntless15]

sorry , new computer keybord