Trigger dissasembly?

FallibleFlyer · 07-13-2008, 01:43 PM

Hey there, Im trying to completely take apart my P68. At the moment I am stuck on the trigger frame. Everything is out EXCEPT for the safety and trigger, how does the safety come out?

c6quad · 07-13-2008, 04:01 PM

you have to remove the dowel pin that holds the trigger in. then you wiggle the trigger around a bit and the safety will slide right out. it can be a pain to find the right spot but when you find it, the safety will slide out very easy.

FallibleFlyer · 07-13-2008, 04:27 PM

I got it. Thanks a lot c6quad.

Also, is there a link on how to take apart the valve?

c6quad · 07-13-2008, 06:06 PM

no problem. your welcome.

check the sheridan section in the armory forum here. it should be stickied.

FallibleFlyer · 07-13-2008, 06:37 PM

I believe mine is the cartridge type, its not threaded in.

c6quad · 07-13-2008, 07:57 PM

well that's easy then... just take out the front grip frame screw(as well as the rear screw too) and the valve will push right out. then just unscrew the valve body.

ThePixelGuru · 07-13-2008, 11:00 PM

If it's got no threading, take three old 12g powerlets and push them into the valve tube until the valve falls out the other end.

07-13-2008, 01:43 PM	#1 (permalink)
FallibleFlyer Active Member Join Date: Apr 2008 Location: Henrietta, NY	Trigger dissasembly? Hey there, Im trying to completely take apart my P68. At the moment I am stuck on the trigger frame. Everything is out EXCEPT for the safety and trigger, how does the safety come out?

07-13-2008, 11:00 PM	#7 (permalink)
ThePixelGuru Active Member Join Date: Oct 2007 Location: Massachusetts	If it's got no threading, take three old 12g powerlets and push them into the valve tube until the valve falls out the other end. __________________

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search

07-13-2008, 04:27 PM	#3 (permalink)
FallibleFlyer Active Member Join Date: Apr 2008 Location: Henrietta, NY	I got it. Thanks a lot c6quad. Also, is there a link on how to take apart the valve?

07-13-2008, 06:37 PM	#5 (permalink)
FallibleFlyer Active Member Join Date: Apr 2008 Location: Henrietta, NY	I believe mine is the cartridge type, its not threaded in.