mcarterbrown.com  

Reply
 
Thread Tools Search this Thread
Old 05-12-2009, 08:56 PM   #11 (permalink)
For gits and shiggles
 
hank_k's Avatar
 
Join Date: Jul 2007
Location: St. John's, NL

The bolt goes about 1/4in or so past the breach, so it shouldn't be too bad to guess where to put it .. if you shine a light at the gap between the feedtube and the barrel you should get a nice little spotlight effect inside the barrel to judge from
__________________
Complaints Department
Hours of operation:
Mon - Fri 11:00am - 11:05am (closed between 11:01 and 11:04 for lunch)
Sat - Sun 12:30pm - 12:31pm (weather dependant)
hank_k is offline   Reply With Quote
Old 05-12-2009, 09:30 PM   #12 (permalink)
Rec Poster
 
WorldStrike's Avatar
 
Join Date: Jun 2008

I'm in the process of doing it now. I measured the entire part of the bolt that was internal when the marker shoots (not that nub at the back) and to the bottom of a regular paintball right on the edge of it (since you pump the marker forward after pumping it back to complete the process). It came out to about 3 inches, so I'm going in about 3 and 1/8 of an inch. That way, the bolt won't hit it, the ball won't quick hit it, but the ball won't have much space to move at all within there. I have the body laying on its side and am making two marks, one on the left and one on the right (or, since I currently have it laying, one on the top and one on the bottom). I'm re-applying a coat every 30 minutes or so, I'll probably do it 4 times.

Hope it works well.

Last edited by WorldStrike; 05-12-2009 at 09:50 PM.
WorldStrike is offline   Reply With Quote
Reply

  mcarterbrown.com » Paintball » The Armory » Sheridan

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

Forum Jump


All times are GMT -4. The time now is 10:54 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO
© MCB Network LLC