mcarterbrown.com

mcarterbrown.com (http://www.mcarterbrown.com/forums/)
-   Tiberius Arms (http://www.mcarterbrown.com/forums/tiberius-arms/)
-   -   need help with T8 mag release (http://www.mcarterbrown.com/forums/tiberius-arms/234777-need-help-t8-mag-release.html)

Charon214 06-02-2013 07:47 PM

need help with T8 mag release
 
Hey guys, just got back from the first field day with a new-to-me t8. Fell out of its holster a couple times and when I went to fire it fired twice then nothing. Brand new co2 cartridge. Of course when I go to check the mag I discover that the mag release has come out at one point. Has anyone dealt with this before? Also how am I suppose to get the mag out at this point? Thanks, im new to TA but im loving it

biteweasel 06-02-2013 08:48 PM

By "the mag release has come out" do you mean the actual button/slide bit has fallen off!?

skullcandy1993 06-02-2013 09:22 PM

pictures would be helpful, not quite sure whats happening here

Charon214 06-02-2013 09:50 PM

3 Attachment(s)
Pics are below. I'm not sure what happened. I have a fully loaded mag in there still, fired 2 shots then nothing. Its not dry firing, its not doing anything. I can pull the trigger with no resistance. Its a fresh 12 gram so I'm hesitant to try to take it out while its still pressurized. This gun was a bit abused when I bought it, unknown tool marks etc. Replaced all the orings and it seemed to work fine when I tested it...
Attachment 39353

Attachment 39354

Attachment 39355

skullcandy1993 06-02-2013 10:16 PM

looks like it snapped and part of it is still in the grip. Take it out and replace it. Should fix the problem.

Charon214 06-02-2013 10:53 PM

awesome thanks so much for the help. Any advice on getting the mag out as it is right now?

skullcandy1993 06-02-2013 11:06 PM

Take a screwdriver (flathead preferable) and try to straighten out/knock out the other half of the mag release. Be careful though, the mag being gased up isn't going to do you any favours.

anomoly40 06-03-2013 12:14 AM

Try to back off the puncture screw on the bottom of the mag to relieve that gas. O-rings and seals are cheaper than eyes.

Nightstar 06-03-2013 04:30 PM

You could just unscrew the grip-frame assembly from the body and push the trigger pin through. You're going to have to separate these parts to replace the mag release anyway. You'll then be able to see what's going on from the top side.

Charon214 06-03-2013 10:15 PM

I discovered I couldn't get the mag release to disengage while it was pressurized anyways so I had to vent the cartridge in the gun. Came out pretty easy after. Thanks for the help everyone!


All times are GMT -4. The time now is 04:24 PM.

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO
© MCB Network LLC