Custom E-bolt Project
So I'm in the process of compiling ideas for a fully custom Tippmann 98 e-bolt. I'm looking at making a custom 2 way ram but the issue I'm running into now is the electronics. I need to find a relatively small board to fit in the grip frame area along with a board and 9V battery. Anyone know of a cheap board that can run a 2 way ram? A one way e-bolt ram runs with a 3 way solenoid so I think I would need a 4 way solenoid correct?
i modified an ion board by unsoldering the noid and wiring in an intimidator noid then i used an ion eye board unsoldered the eyes and wired in timmy eyes and i was using a 2 way ram (it was a single action but i took the spring out and tapped another hole) with dual qevs, in all i had a 22+ bps monster that for the most part looked like a stock 98 lol
as for boards these will work
shocker (not shoebox)
and a few others
Not bad but I'm not that great at soldering. I know this isn't going to be a drop in kit but I'd prefer to modify the body than the electronics.
If you would rather modify the body try doing an eblade conversion on the handle. Worrblade/karnivor/eblade framed Tippmann 98 custom EBOLT
I hope this helps. I am trying to build an A5 ebolt right now.
Would love to see your project. Shouldn't be too hard. I already have everything I need so buying a new frame and accessories would be too much money. Got a Viking WAS board with all the hook ups for it so I just need to make everything fit and extend the wires
I am actually having trouble finding a cylinder for my project. I have a board, solenoid and microswitch, but nothing for them to operate.
They are hard to come by. I have a BSI ebolt setup. Just missing the battery harness.
|All times are GMT -4. The time now is 10:51 PM.|
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO
© MCB Network LLC