Paintball

[Bones]

Ok, my Sniper II has been sitting in the basement a little bit too long.
I had it running with an E-1 and then later an E-2 frame.
I sold that, bought an ANS 45 Slider frame and don't have the right screws for it.

I was wondering if somebody could tell me the screw sizing so I could go pick some up, or if anybody has any for sale, please let me know.

(The screws that hold the trigger frame onto the body)

[ceverhart]

1/2 inch 10/32? I forget the thread size sometimes, just take the body into ace hardware or go to Mass Exctinction Paintball, the owner is a mcb member.

[Bones]

Originally Posted by ceverhart

1/2 inch 10/32? I forget the thread size sometimes, just take the body into ace hardware or go to Mass Exctinction Paintball, the owner is a mcb member.

Thank you.
I think I just may bring the body into Home Depot.
The only thing is I would leave the trigger frame at home, so I would need to know the length that I would need.

Are you pretty sure that it is 1/2 inch?


Edit:
Well, I picked up the screws at Home Depot.
It doesn't work when the screws are holding it tight to the body.
For now I put a paper clip between the frame and the body, and it works fine.
It needs to be slightly separated for it to work, does anybody know why?
The paper clip works, but I want to know if I can find a better option.

[Chris Mader]

For an ANS .45 frame the front screw is 10-32 x 1/2" and the rear screw is 10-32 x 3/8".

[Bones]

Originally Posted by Chris Mader

For an ANS .45 frame the front screw is 10-32 x 1/2" and the rear screw is 10-32 x 3/8".

That is exactly the explanation that I am looking for.
Thank you very much.