| ||Thread Tools||Search this Thread|
|08-21-2007, 09:20 PM||#1 (permalink)|
Screw Sizing on a 2002 Autococker
Ok, my Sniper II has been sitting in the basement a little bit too long.
I had it running with an E-1 and then later an E-2 frame.
I sold that, bought an ANS 45 Slider frame and don't have the right screws for it.
I was wondering if somebody could tell me the screw sizing so I could go pick some up, or if anybody has any for sale, please let me know.
(The screws that hold the trigger frame onto the body)
|08-22-2007, 05:14 PM||#3 (permalink)|
I think I just may bring the body into Home Depot.
The only thing is I would leave the trigger frame at home, so I would need to know the length that I would need.
Are you pretty sure that it is 1/2 inch?
Well, I picked up the screws at Home Depot.
It doesn't work when the screws are holding it tight to the body.
For now I put a paper clip between the frame and the body, and it works fine.
It needs to be slightly separated for it to work, does anybody know why?
The paper clip works, but I want to know if I can find a better option.
Last edited by Bones; 08-22-2007 at 07:21 PM.
|Thread Tools||Search this Thread|